Easy Bake Oven for my 3D Prints

I previously have been using the same light I use for my nails to cure my resin prints on my Form 2. It seemed to be doing the job until I started printing small detailed pieces, I would notice warping or shrinking in my parts. I finally decided to invest in Form Cure for my 3D Printed cosplay props. 

‍

“The big selling point for me was that the Form Cure uses heat and light for your post cure process, it also rotates 360degrees to cure your prints evenly.”

‍

 Prints are fully cured after "baking" in the Form Cure for 30-60 minutes(depending on the material). Previously I was curing my prints in my nail light for 4-6 hours and rotating them manually, and my results weren't always consistent.

‍